if its not a hot day then you can use your water brush by flicking water to the surface or you could use the hose on a fine spray

you apply your mix to the surface with the trowel approx 10mm thick, per coat, don't worry about getting a good finish at this stage, 

with small areas like bays its best to rule off as you go, make sure that you leave no hollows, fill out if necessary

we set beads in the angles of the bays and bell beads (drips) at the bottom of the bays and above the plinth. we don't always use angle beads on external work, we prefer to gain the angles with the use of the featheredge and level, where another set of hands holds the featheredge level on the angle and you rub up to the edge of the featheredge, but if working with many angles you can save time with angle beads.

back || continue